Farmall & IHC Tractors Discussion Board |
Re: regarding cheap fresh air system for painting
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FC on March 17, 2005 at 11:49:11 from (64.141.134.66):
In Reply to: Re: regarding cheap fresh air system for painting posted by Bill in NC on March 17, 2005 at 11:38:07:
Bill is right, and I also believe that unless something has changed you may have to have the tank certified occassionally in order to get someone to refill. I used to be in the fire service, and refilled these. I remember there was a difference between intervals on the old steel tanks, and the aluminum with fiberglass wrap. Some areas might be a tough find to get someone who had the high dollar compressor to refill unless you had a buddy on the local FD, or a scuba outfit close. The newer ones are lighter, but I certainly would not want to pack around one of the steel tanks for very long while painting, and when I finally got out of the fire service you only had less than 30 minutes of air (20 was about all I ever got out of one and it depends on your physical condition, and how fast you consume the air - and one of those on your back will increase your stress for sure).
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|