Farmall & IHC Tractors Discussion Board |
Re: Temperature gauge reading low?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nathan in Texas on March 25, 2005 at 08:43:06 from (216.167.183.158):
In Reply to: Re: Temperature gauge reading low? posted by Allan in NE on March 25, 2005 at 08:26:02:
I just think having the temperature gauge is a good idea. The old one was broken and the previous owner didn't even know that it was supposed to be a temperature gauge. As far as the coolant level the manual says it should be 2 1/2" inches from the top of the cap. Mine was at the right level until I changed the temperature gauge out and now it is probably 3" from the top of the cap. I thought that you needed a gasket since these are pressure type cooling systems? I'm not worried about the tractor overheating but it does make a mess when the coolant overflows everytime you shut the tractor off and sometimes while it is running for a couple hours straight. Right now antifreeze is not cheap. That's why I'm wondering about replacing the cap. Hopefully the gasket will solve the overflowing problem. Thanks, Nathan
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|