Re: Installing Wet Sleeve Liners

Posted by Hobo,NC on March 31, 2005 at 17:45:21 from (67.141.255.168):

In Reply to: Installing Wet Sleeve Liners posted by Carp on March 31, 2005 at 13:49:06:

Clean the block good at the lower were the sleeve fits. I take the square end of a file and realy clean the grove in the top of the block were then sleeve sits. Prefit the sleeve with out the o-ring it should fall in with no resistence. Install the o-ring I lube with DURA SIL 1000 I git from NAPA its $11 to $15 for a small bottle and the best rubber lube avalible. I use it enny were I need to install o-rings, water hoses, fuel lines on enny rubber part. A bottle will last a DIY a life time. The sleeve shoud go in with out much fource. With DURA sil I kin install'em by hand

Follow Ups:

Post a Followup Name: E-Mail: Hide: Yes No Hiding your address protects you from spam generators but allows you to receive email response notifications. Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]