Re: Finally painting my H

Posted by Paul in Mich on April 14, 2005 at 04:04:21 from (152.163.101.13):

In Reply to: Finally painting my H posted by Mike3501 on April 13, 2005 at 17:00:23:

Mike, I"ve restored 2 tractors, and havn"t used a sand blaster on either, and while I suppose a sand blaster would be ok for some parts taken away from the tractor, I would never sand blast anything near the tractor or anything that if invaded by sand would cause damage. That just about leaves wheel weights and rear wheel castings. I do however use an air needle scaler for all the castings which works great along with wire brushes, pocket knives, sand paper, wire wheels, oven cleaner, carb and brake cleaners, and anything else that ends up, while being labor intensive, gets the job done. As Cowman says, preparing to paint takes far much longer than painting itself.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]