Farmall & IHC Tractors Discussion Board |
Re: steering
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Derek Broerse on April 24, 2005 at 11:28:56 from (206.186.115.242):
In Reply to: Re: steering posted by janicholson on April 24, 2005 at 11:18:04:
You may be right, I'll look into it a little closer. I just went out to have a peek at it to satisfy my curiousity (should have worn hip-waders ;)j/k) and confirmed that the tires sizes are both 6.00 x 16's, one being a Goodyear and one is a Galaxy. Didn't have a pressure guage handy. Also noticed that the axle pivot pin has some slop as well (probably normal compared to the rest) so while the axle can already 'rotate' front to rear it can also 'pivot' front to rear on the main mount too. I think all these things added together make for my problem. If the weather clears next week maybe I can tear into this stuff. The loader needs a total revamp as well, so maybe I'll take it off for that part.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|