Farmall & IHC Tractors Discussion Board |
Re: HELP!! Still can't find problem!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pale Rider on April 30, 2005 at 18:59:33 from (131.107.0.77):
In Reply to: HELP!! Still can't find problem!! posted by Granger on April 29, 2005 at 23:05:56:
Speaking as an electician, the advice Hugh gave about battery cables was very relevant. As was the advice on using the volt meter to check the voltage drop at various points. I"m sure by now you are getting tired of being told to check and clean the connections. I would offer a thought on the battery however. I"m not sure how it was checked and by who and with what kind of credentials. An essentially dead battery can very easily still show 12 volts with a volt meter(or 6 volts depending on what you have) and still be a dead battery that will not turn your engine or keep your lights lit for more than a few seconds. The issue is one of the amperage it is able to deliver and what kind of condition the inside components are in. I won"t go on and on about the minutae of battery physics but I have run into more than a few people at various auto, parts supply outlets and even battery retailers who tell you your battery is good and simply don"t know what they are talking about or what tests to run. I remember trying to make good on a warranty, some kid telling me my dead battery was good simply because his meter told him 12 volts. There was no way to convince him and I could tell by the look in his eyes that he thought that that I was the one who didn"t know what I was talking about simply because his meter showed 12 volts. I just gave up wasting my time and went to another outlet and didn"t ask them--this time I TOLD them my battery was dead and I needed a new one and was quite adamant about it cutting them off at the pass before we started heading down the "the meter says 12 volts" road again. If you have any other 6 volt batteries around I would try jumping it to your tractor and testing the results. As an alternate you might purchase a new one and try jumping your tractor with it before you install it. If it makes no difference you could simply return it. If you are convinced about your terminations, your battery cables are properly sized and your volt meter (assuming you know how to properly check them) finds no large voltage drop over any component I would strongly suggest you address the battery. I suspect you might be surprised at the results.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Variable pulley for case 1530 skid loader
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|