just to be sure.... is this correct ?

Posted by arod on May 20, 2005 at 12:05:41 from (130.20.12.207):

In Reply to: Re: farmall H, 12V resistor smokes after wiring l posted by Bob M on May 20, 2005 at 11:20:39:

ok... Hmmm. So should a fella NOT wire up to the junction block where the ignition comes together behind the switched side of the ign switch.

Three wires exist on that junction to be exact:
1) wire from the alternator that reads "TO BAT"
2) wire supplying current to the ign switch
3) wire to the positive battery cable for charging

This is NOT the place to grab a 'hot' for accesories then?

Follow Ups:

• Re: just to be sure.... is this correct ? captaink 12:10:17 05/20/05 (1)
  • Re: just to be sure.... is this correct ? arod 12:15:06 05/20/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]