Farmall & IHC Tractors Discussion Board |
Re: adjust length of arms
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on May 25, 2005 at 12:46:27 from (204.249.178.138):
In Reply to: Re: adjust length of arms posted by Allan in NE on May 25, 2005 at 08:44:30:
I grew up with NF tractors. Lined the radiator cap up with the mark, done it enough times I don't have to think about it. I have on occasion planted with "modern" tractors with the usual WFE, that someone set to run the front wheel in the mark (probably me)-- make one pass turn around, put the radiator cap on the mark -- you know the rest of the story. Reason I said measure from the wheel track, is that I prefer to measure even row widths. Usually used 30 inch rows, easier for me to remember 30+30=60, than 30+(30/2)=45. I'm a measure twice, cut 3 times person, sometimes worse than that.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|