Farmall & IHC Tractors Discussion Board |
Re: 240 utility hydraulics problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim Becker on June 02, 2005 at 14:28:21 from (71.96.20.180):
In Reply to: 240 utility hydraulics problem posted by Marvin M on June 02, 2005 at 06:28:44:
240 hydraulic reservoir is in the bell housing. Your new manual should give you the specifics. If you changed the filter without adding any fluid, it may now be too low to operate. The pump is a simple gear pump. Hardly anything goes wrong other than the seal on the input shaft leaking. When this happens, it will dump the hydraulic oil into the engine. If your hydraulic oil statrs disappearing, check the crankcase for being overfull. If you have that problem, fixing is not a difficuly do-it-yourself job unless the shaft is worn too far for a new seal to hold.
Follow Ups:
Home
| Forums
Today's Featured Article -
A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|