Farmall & IHC Tractors Discussion Board |
Re: Haying Tales
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh Mackay on June 21, 2005 at 07:17:29 from (216.208.58.190):
In Reply to: Haying Tales posted by Michael Soldan on June 20, 2005 at 20:01:03:
Mike: Got 2 or 3 good ones. Had a wagon load of hay get away in the yard once, was headed fot two Pontiacs and an Olds. Dad saw it coming from seat of Farmall 300. He was in 4th gear and was able to let it hit rear wheel of 300 side on, and before it got rolling very fast. Silage wagon parked at silo, had been there about a week since finishing filling silo. Our children pestered Marg. until she took them swimming at park. I was in barn milking, rain, electrical storm and wind blew up, I heard a crash. Looked out and silage wagon tongue had hit concrete doorstep of house. Wagon was parked right in spot where new Olds would have been, had Marg. not taken children swimming. Last one, my brothers first load of hay with bale thrower. One of the early New Hollands with Briggs engine thrower. The long cable control for throttle was less the ideal. 84 bales on the wagon, close to 200 on the ground and one bale on top of the multi wire telephone lines along the highway. My cousin (New Holland dealer) has that on vidio. Frank gave thrower a bit more throttle under telephones lines and bale went up between wires and came to rest crossways on top of wires. Bet that one caused a comotion on the party line.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|