Farmall & IHC Tractors Discussion Board |
My N has a new barn buddy - BUT...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by N4Noel on June 29, 2005 at 08:31:36 from (66.83.255.42):
Hey Folks, First time on the Farmall Forum. Been hangin my hat at the Ford N Forum, Up til now. Ran acrost a 52 Cub and purchased it for the bill at the mechanic shop - no more. It had had a rebuilt governor and rebuit carb put on, all new tune-up parts, new used rear rims (fresh paint, but pitted steel underneath), new battery, engine oil/filter and coolant change, and tubes all around. It starts wonerfully and purrs like a cat until you get her in a light load. Such as climbing the hill out back. It should be able to handle this hill with little to no throttle, but instead (even at high throttle) the engine purrs to a stop. No kicking, no backfiring, not even a spudder, just calmly loses RPM until she quits. Starts back up like she"s ready to go. It will take the hill, but any more load and it quits. I can kill it easily by brake loading. There is some blow by but no smoke to speak of. The previous owner (not a tractor type - inherted it many years ago and let it set in storage til the tires were flat and it would not run) put it in the shop to git her runnin and was shocked at the speed at which the bill climbed and stopped at "runnin" not "runnin right". What"s the Cub Trick? I have to assume the mechanics or rebuiders failed somewhere, but wanted to check with the expert hobbyist before I started reworking and exploring. I have adjusted the governor rod to either side of the original setting to see no difference and have tweeked the carb adjustments around with no affect. Just wanted to introduce myself and get the Cub rolling. I don"t know what I"ll use it for, but it sure looks good in the barn. Noel
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|