Farmall & IHC Tractors Discussion Board |
Re: Farmall c crank pulley
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pharmall on July 11, 2005 at 10:53:58 from (68.9.106.167):
In Reply to: Re: Farmall c crank pulley posted by El Toro on July 11, 2005 at 10:06:36:
Yes, the '48C crank is tapped with a 1/2" coarse thread. Waiting for UPS to deliver a puller to get the pilot bushing out before getting the crank ground. Always wanted one and will need it to get a bunch of the other oil seals and bushings removed as well. Been cleaning and painting miscellaneous parts in the meantime. Rebuilt the magneto and generator. Working on the governor now. I need to post a picture of the governor innards sometime to ask a question. Putting the engine together will be the easy part. It's things like the axle seals, brake seals and tranny shaft oil seal and bearing that will probably give trouble. Haven't started to take them apart yet. The transmission shaft has about .05" play side-to-side and up and down, so the bearing is probably shot. The tranny is sitting all by itself looking very lonely! Then there's that honey-dew list...
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|