Re: How to plumb a 3 pt hitch on an H

Posted by CNKS on July 15, 2005 at 18:00:28 from (204.249.178.138):

In Reply to: How to plumb a 3 pt hitch on an H posted by Dave in CT on July 15, 2005 at 15:57:56:

If you have the belly pump and no "Christmas tree" (factory remote), just run one line and tee it to the cylinders. As you say vent the down side of each. You have two way already if you have the factory remote. If you are adding a control valve in order to have 2-way the procedure is (I think): Outlet to control valve, control valve to up cylinder, down cylinder to control valve, control valve to belly pump inlet. You can either tee the line from the control valve to the cylinders, using one outlet, or use both outlets (the front one on each side), one to each cylinder. The return line should connect the cylinders together, however. I have a Super H with a live pump, no factory or aftermarket control valve, power up, gravity down with just the main control lever, a single line teed to the dual cylinder Saginaw 3-point. It works fine without any additional valving, except vents for the down portion of the cylinders.

Follow Ups:

• Re: How to plumb a 3 pt hitch on an H Dave in CT 18:45:47 07/15/05 (2)
  • Re: How to plumb a 3 pt hitch on an H CNKS 19:13:03 07/15/05 (1)
    • Re: How to plumb a 3 pt hitch on an H nositri 19:34:33 07/15/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]