Re: 1461 Farmall H

Posted by Andy Martin on July 20, 2005 at 05:07:15 from (64.219.39.195):

In Reply to: 1461 Farmall H posted by cashley on July 19, 2005 at 19:18:52:

First slowly crank the engine (by hand) until the first of the two timing marks is aligned with the timing pointer. The magneto should trip just as the mark passes the pointer.

If it does not trip by the time you get to the pointer, leave the engine set at TDC (first timing mark aligned), loosen the magneto adjusting bolts, and slowly roll the top of the magneto toward the engine until it trips. Tighten it up and check it by rollong the engine over again.

If it has already tripped, loosen it and move the top away from the engine. Then crank to TDC and move the magneto in until it trips.

If the magneto has been disassembled or is from another tractor, you will have to determine TDC on No. 1 and make sure the rotor is pointed toward the No. 1 post.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]