Farmall & IHC Tractors Discussion Board |
Re: Number 93 Combine
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by El Toro on July 30, 2005 at 08:42:45 from (205.188.117.73):
In Reply to: Number 93 Combine posted by Fredd on July 30, 2005 at 08:18:39:
Are you sure you have the correct points for that engine? If they are, you may need to run a point file through them. Have you installed new plugs lately? They may be breaking down under load if they haven't been changed lately. New plugs wires may in order too. When you install those new points again, remove the coil wire from the distr. cap and with the ignition switch on, hold the coil wire within 1/4" of a ground on the engine and with the points closed snap them open a couple of times and see if you're getting a good spark from that coil wire. If you are, the engine should run. You may need to open the main jet adjusting screw CCW on the carburetor to see if the it's set too lean. Look that distr. cap over very carefully for any cracks. Hal
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|