Farmall & IHC Tractors Discussion Board |
Re: IH 300 or 350?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Janicholson on August 01, 2005 at 05:54:09 from (199.17.6.175):
In Reply to: Re: IH 300 or 350? posted by CNKS on July 31, 2005 at 19:30:00:
Those of us who have lived (or still live with tractors from our youth believe they are the berries under all conditions. I'm a 350ute type. The choice seems unimportant between the 300, and the 350. Both seem to be very good choices based on your circumstances. Upon ownership, the following are important: 1) change all fluids trans, dif, hy-tran, and engine oil/filter. 2)Clean all filters and screens (hydraulic suction screen particularly). 3) Run the most inexpensive grade of clean gasoline, or up tp 15% gasohol. They will eat it just fine, the compression was designed for even worse gasoline, and they do not need lead, or lead substitute. (I'll stick by this from massive experience, others may protest, but no-lead gasoline is one of the cleanest burning deposit free conventional (non-compressed gas)fuels. 4) if 6v neg ground, use "o" size cables and clean all connections to shiny bright. Coat all connections with Dow 111 silicon non-conductive grease (it is clear, and doesn't run off, and keeps corrosion to nothing. If 12v neg ground with an alternator & 6v starter, enjoy they will last without worry. 5) use the TA, it is a great tool for convienient control of ground speed and engine saving gear change without stopping. Use keeps them younger than avoidance. (ours has never been down from day one 1 in 1957 to today, and it is used more often than the clutch) Lots of luck and many happy hours with your to be ute, Jim Nicholson
Follow Ups:
Home
| Forums
Today's Featured Article -
Maintaining Rubber Tires - by Staff. The broad use of rubber tires on farm tractors and machinery has resulted in a great saving in both time and operating costs since the time of steel wheels. There are, however, certain basic fundamentals in the care of tires that should be followed carefully if the owner is to derive maximum benefit from his or her investment. First and most important is to maintain proper pressure for the work at hand. Your best guide to proper inflation is the operator's manual or instruction book tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|