Re: steering shaft pivot oil seal orientation

Posted by Theman on August 03, 2005 at 10:55:01 from (65.248.77.5):

In Reply to: Re: steering shaft pivot oil seal orientation posted by Kevin Brooks on August 03, 2005 at 07:55:27:

The newer thrust bearing for the H has a metal shield around the OD. I place it on the shaft so that the stationary part of the bearing is next to the stationary part of the bolster. Keep in mind that the bottom of the thrust bearing is the moving part. So - the part of the bearing that is attached to the shield goes up. That said, you are working on an M and you describe an inner hub. Since an inner race would turn with the shaft, it would be on the bottom.

The felt seal should go on the shaft after the thrust bearing then the tin retainer goes over the felt.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]