Re: Timing for IH 46 Baler

Posted by JB2 on August 03, 2005 at 20:41:27 from (69.196.154.214):

In Reply to: Timing for IH 46 Baler posted by GeorgeL on August 03, 2005 at 13:08:27:

Hi George, the timing was all done by gear boxes and shaft drive. So should not be out of time unless gear box was opened. Other vendors had drive chains that had to be timed.
There were 3 shear bolts, one in PTO to flywheel connect, another on sweep fork, another on the knotter to needle drive lever. There was timing in the knotters for bill hook and twine disk.

Where do you think yours is out of time?

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]