Farmall & IHC Tractors Discussion Board |
Re: IH H4 magneto produces no spark
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MagMan on August 15, 2005 at 19:37:43 from (205.188.117.73):
In Reply to: Re: IH H4 magneto produces no spark posted by I Bleed Red on August 15, 2005 at 19:03:21:
Well usally the culprits are the bakelight washers. Where the wires hook up you have to make sure that nothing is getting close to the aluminum check for cracks in the wire insulation where it goes into the coil, Is the brass washer under the screw that holds the point base down? I have never seen the internal rotor on a J4 or H4 loose its charge unless it was a special cirumstance. So I really highly doubt it will be that.I have had a few that I scratch my head over also and I have rebuilt a lot of them every once in a while you get one that just defys the odds but I have not had any beat me yet. Try a new condenser.Clean inbetween the points with some berrymans or equivelent and file never sand the points. Let me know how you make out. JON
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|