Farmall & IHC Tractors Discussion Board |
Re: Throttle Body Injection for 50 Yr. Old Farmall
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by chadd on September 07, 2005 at 15:26:21 from (155.92.31.135):
In Reply to: Re: Throttle Body Injection for 50 Yr. Old Farmall posted by RustyFarmall on September 07, 2005 at 13:51:52:
Yes, you are right, thank you for catching my mistake. However, the engine computer has fuel curves that are set to optimize fuel delivery (enrichen the mixture) at rpms that are higher than that. What I meant is that wide open throttle in the injection system is set for when the engine reaches redline (on many cars 5000 to 8000 rpm). Most cars (four cylinders and sixes) are not making anywhere near max power at 1800 rpm. Tractors are. Many engine computers operate in open loop configuration at such low rpms. This means that they don't pay attention to load, temperature, or several of the sensors, instead they follow a prerecorded fuel map in the computer. The ECM would need to be reprogrammed accordingly to make the tractor operate respectfully. These are just my thoughts. I am no expert, so if something in my logic seems wrong, it probably is. Just let me know so I don't give the wrong answer again. Thanks for your correction.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|