|
Farmall Tractors Discussion Board |
Re: Quick Hitch/3pt--Help!
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Mudcat49 on December 23, 1999 at 15:46:27 from (209.26.211.41):
In Reply to: Quick Hitch/3pt--Help! posted by Mark on December 23, 1999 at 15:20:59:
IHC and some aftermarket people made a 3 point '"adaptor" for the IHC 2 point hitches, we used them for years on our IHC fast hitch equipment> the only swinging action we would get was from the 2 point hitch> we had super c's with fast hitches and we had to cut the prongs down as the super c hitch prongs were not as fat as the others. another way to make a IHC fast hitch fit 3 point equipment was to find some fast hitch male prongs and weld some 3 point pin balls to them, and to build a bracket up top for your top link.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
