Farmall & IHC Tractors Discussion Board |
Re: the wheels at the narrow front axle are dancin
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul in Mich on September 18, 2005 at 07:01:51 from (152.163.101.13):
In Reply to: the wheels at the narrow front axle are dancing. posted by Gideon Jakubovitch on September 17, 2005 at 13:21:51:
That wobble is to be expected from years and years of use. It can be minimized, however, bu installing a wedge between the lower and upper bolster, where the narrow front bolts on. The wide side of the wedge in front and the narrow side in back creates a castor like condition which in essense places the front wheel axles behind the pivot point of the steering. It wont take all the wobble out, but some. To my knowlege, the wedge is 1/4 to 1/2 inch thicker in front than at the rear. YOu may have to have it custom made. Short of that, you can always rebuild the steering gear mechanism.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|