Farmall & IHC Tractors Discussion Board |
Re: OT - Cement Mixer
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scotty on October 05, 2005 at 09:28:17 from (199.231.49.128):
In Reply to: Re: OT - Cement Mixer posted by Dave in CT on October 05, 2005 at 07:01:25:
Hi Dave, I would think you could drive it off the belt pulley, but of course belt pulley RPM is much higher than PTO RPM. as far as the belt goes, long as the pulley is crowned I would think it would work. I liked your driveshaft idea better myself. I have an old belt pulley off of my Super A that has a piece missing, your welcome to it if you want it. Im in Seymour, dont know how far that is from you! I realize that pulley wont work on your H but if you need it for the mixer you can have it. I bought a replacement a couple of years ago. scotty
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|