|
Farmall & IHC Tractors Discussion Board |
Re: HELP!!! IHC 2-hole steel corn sheller!!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeb2N on October 11, 2005 at 18:18:38 from (12.219.226.237):
In Reply to: Re: HELP!!! IHC 2-hole steel corn sheller!!! posted by El Toro on October 11, 2005 at 17:44:17:
Well, the problem is, i want to try and stay as original as possible so if i had new gears made, i'd have them cast using the 1/2 of a gear that I still have as a pattern and then have the teeth machined on there and that would be a significant cost. Ironically, I just saw one listed on eBay although the big gear on the end of the cob elevator is different from mine. I have no idea what model is but I can get a few numbers off of it. I was thinking it might be in Wendel's "150 Years of International Harvester" book. Naturally, i don't have that book. Anybody care to try and look it up for me? Thanks! Jeb
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
