Farmall & IHC Tractors Discussion Board |
Re: My Cousin's H. . .She's a Runner!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John T on October 17, 2005 at 06:58:06 from (66.244.90.98):
In Reply to: My Cousin's H. . .She's a Runner! posted by David Kronwall on October 17, 2005 at 06:32:44:
David, if youre at POSITIVE GROUND, the coils + becomes the "to distributor/ground" while its - is what receives power from the ignition switch i.e. "to switch" The dealer is "wrong as rain" on the coil, however. Heres the deal, if its a 12 volt system, you can use a 6 volt coil simply by adding an external voltage dropping (12 to 6) series Ballast Resistor ahead of the coil after the ignition switch. However, if its a 6 volt tractor, the coil dont somehow automatically mysteriously change and if youre using a 12 volt coil it will still produce some spark, but not as good as if you used the correct 6 volt coil. A coil is more of a current device then a voltage device and regardless if a 6 or 12 volt unit, it runs and switches about 4 amps of current through its primary winding. To do that, A 6 volt coil has about 1.25 to 2 ohms primary resistance while a 12 volt has more like 2.5 to over 3 ohms. Therefore if you use a 12 volt coil at 6 volts, youre only running about half the normal amps through it as required for a good hot spark. My guess is the spark would be more of a light wimpy yellow then a good hot blue spark under such use. My advice if youre at 6 volts GET A 6 VOLT COIL. Myself n Texas Denny n Bob have a hot friendly discussion over on the AC board about coils, go read that if you wanna get cornfused n bored lol Good Luck n God Bless John T Nordhoff in Indiana, retired electrical engineer
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|