Re: How to remove the oil guage

Posted by El Toro on October 21, 2005 at 07:40:44 from (64.12.117.13):

In Reply to: How to remove the oil guage posted by fenton on October 21, 2005 at 06:12:42:

I would have agree with Bob & the Vet. You should use some plasti-gage to determine your bearing clearances. If it's only worn a few thousands beyond specs you can install .002" undersize bearings.

On the other hand if the engine is sludged up you may be better off to pull the engine and have it degreased. Those blocks don't have cam bearings,
but your local auto machine shop can check your crankshaft for wear and determine if it needs to
be ground undersize. If you go to all that trouble I would install a new sleeve & piston kit
too. Hal

Follow Ups:

• Re: How to remove the oil guage fenton 07:59:46 10/21/05 (2)
  • Re: How to remove the oil guage El Toro 08:04:21 10/21/05 (1)
    • Re: How to remove the oil guage fenton 08:22:03 10/21/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]