Farmall & IHC Tractors Discussion Board |
Re: EMERGENCY 454 HELP!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Janicholson on October 28, 2005 at 19:29:38 from (66.173.50.128):
In Reply to: Re: EMERGENCY 454 HELP!! posted by Galen on October 28, 2005 at 17:16:38:
In the picture I see what appear to be screws holding on the top pivot where the fork on the lever is mounted. If this screw was removed, and the lever mooved as far as it can go toward the right in the photo, the lever might clear the shift rail and be able to be taken off the shaft. The sliding gear will need to be moved (down in the picture) to allow the shaft to pull out left. If the shaft will not clear the shaft, the tranny will need to come apart, because the new shaft will need to go in rfom that end. My best ideas, JimN Keep me in the loop.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|