Re: Farmall H front blade

Posted by the tractor vet on November 01, 2005 at 06:25:57 from (4.124.82.138):

In Reply to: Farmall H front blade posted by Ian T on October 31, 2005 at 21:35:26:

Like Dave has said , i made up a plow for the ft. of my S/H from 3 inch channel and some 2 1/2 inch pipe some 3/8th. flat stock and 2 1/2 x 2 1/2 angel and use and old 7 1/2 foot western snowplow used one to the angel cyl. for the lift along with the lift arm shortend up the subframe made up some new mounting points on the subframe attached it to the ft. of the tractor in the mounting holes on the side of the bolster and back to the mounting holes on the side of the rearend housing . It is wide enough for the ft. wheels to turn all the way as mine is a tric. and made a removeable cross member at the back of the subframe before it goes up to the rear mounts on the rearend it is a snap to remove as it is all bolted ya just remove the rear braces from the sub and rearend and remove the cross member pull four bolts out of the ft. mount unhook the quick coupler on the hdy. and this can all be done with either a floor jack or and extra set of hands , with out the plow on the sub it does not weigh that much and it is strong . I just wished that i had live hdy on my S/H but since it is one of the first ones it's like and old H if it had the live power it would also have the power angel but i am to lazzy to to work up some thing on it . I am just like tha old shoe repirman i fix everybody elses stuff and mine is the last on the list and has to be dead before i'll take the time. I built this set up one day out of need during a raggen snowstorm in three and a half hours had everything i needed in the shop even took the time to lay out and drill all the bolt holes . I pulled the S/H in blew the snow off of it pull two pices of three inch channel off the rack layed them on the floor next to the tractor did some massuren and went to cutting welding and drillen . Thenput my pulling weight brackets on stacked a bunch of weight on and went to pushen snow to see if i could break it found out that even with two and a half tons of weight on it i still needed chains so i took two set of old chains from my old 4x4 and added a littel to them and a couple extra cross bars and a hand full of the old stand by trap strapes and now this thing was a D9. It would move more snow then the 580 Case bachoe.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]