|
Farmall & IHC Tractors Discussion Board |
Re: B Farmall Puller
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Shaggy on November 06, 2005 at 21:25:30 from (12.240.5.94):
In Reply to: B Farmall Puller posted by mo4xdadad on November 06, 2005 at 18:14:41:
I can relate to both the drifting apart and wanting to pull a B.The drifting apart was do to me being me. Anyway on the pulling part.I am learning that my B won"t fit in a couple of classes because of the 140 head I put on it.But if you can get a set of 3 1/8 pistons with a decent dome and a C-153 cam and a head off a super A or C along with the manifold and carb it should be in the upper 20"s if not in the 30 HP range. Some say you can cut down a set of 3 1/4 sleeves to fit in the B block.
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
