Farmall & IHC Tractors Discussion Board |
Re: cold valve lash on super h
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RustyFarmall on November 16, 2005 at 12:28:55 from (216.248.75.153):
In Reply to: Re: cold valve lash on super h posted by P and R Pete on November 16, 2005 at 10:49:22:
I kinda learned it by trial and error. I rebuilt the head on my 1940 M, and was determined to do it right, by the book. Made an initial setting on the valves, started the engine and let it warm up real good, then shut it off, removed the valve cover, and began adjusting the valves. Got everything right on factory specs. Let it warm up good, took it for a drive, and did not like the way it ran. Did it all over again, still didn't like the way it ran. Shut it off and walked away. The next day I removed the valve cover, set the valves at .020" with the engine cold, buttoned it up and drove it again. It worked. The valve cover has not been off since.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|