Farmall & IHC Tractors Discussion Board |
Re: M Hand Clutch ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by superih on November 23, 2005 at 05:23:57 from (64.235.131.10):
In Reply to: M Hand Clutch ? posted by GooseCreek Farms on November 23, 2005 at 03:18:24:
Pretty much what everyone else has told you. You can down shift gears with the clutch disengaged ,the gears grind a little, but I don't think that we could upshift. I have one on a Super H it was pretty handy when I ran clover seed with it. They are not that hard to disassemble or remove the entire unit form the tractor, just you will destroy the inner oil seal that seals to the pinion shaft. That seal was no longer available I had to take measurements from it and have a custom seal ordered (not that painful). Sooo, there not that hard to work on and you can remove the entire unit and swap to another tractor. If you are going to do this post again and I can give you some more tips. LC
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|