Farmall & IHC Tractors Discussion Board |
Re: H 4th5th Gear #'s
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Haas on December 03, 2005 at 07:37:10 from (12.65.0.136):
In Reply to: Re: H 4th5th Gear #'s posted by DWV on December 02, 2005 at 17:15:26:
Once had a W-4 parts book but sold it. The "standard" tractors are not on the parts CD I have. I know that the W-4 4/5th gear is different than the H because a friend had replace that gear in a W-4. He could not find one and ended up using the gears out of an H which meant replacing both the sliding gear and the counter shaft gear and maybe some others too, as the 3rd gear is different on the w-4 as well. He used parts out of an H parts tractor. I do have a parts catalog for the I-4 tractor and strangely, the 4/5 slider gear on that is listed as 22 and 34 teeth. That means the input gear is diffenent on the I-4 as well, as the spline on the input has to have 22 teeth instead of 18. Don't know why IH would have done that, but I guess they had a reason.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|