Farmall & IHC Tractors Discussion Board |
Re: Timing a SA distributer Any suggestions welcom
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on December 04, 2005 at 07:32:22 from (205.188.117.73):
In Reply to: Re: Timing a SA distributer Any suggestions welcom posted by scott#2 on December 04, 2005 at 04:37:10:
Another way to find TDC on NO1 piston is once you feel compression is to drop a big handled screwdriver into the cylinder. When the screwdriver quits rising your No1 piston should be at TDC. Your rotor should be pointing to No1 position in the distributor too. You want the handle big enough so it doesn't drop into the cylinder. I would mark the damper pulley with some white paint and then use your timing light. I have the inductive type that you just fasten the plug lead over No1 plug wire. You can use another battery if you need 12 volts or another vehicle to hook to that battery that has 12 volts. Hal
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|