|
Farmall & IHC Tractors Discussion Board |
Re: 450 to 560 wheel exchange
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DWV on December 07, 2005 at 14:13:19 from (205.188.117.73):
In Reply to: Re: 450 to 560 wheel exchange posted by CNKS on December 07, 2005 at 11:39:27:
Don't know about 460 but one keyway axles started showing up on some 450 tractors,mostly one keyway on one side and two on other side.I agree with Hugh that it was done to increase strength.Also more cost savings by just machining one.On the subject I always wondered why some axles have a turned down section 3 to 5 inch wide
inside the axle housing between the bearings and some don't. Also wonder when they started the 2 3/4 axle on 300 - 460. 56 model 300 is early as ive seen.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
