Re: Farmall C touch control

Posted by Janicholson on December 23, 2005 at 17:05:56 from (66.173.50.55):

In Reply to: Farmall C touch control posted by Nat on December 23, 2005 at 15:39:33:

Others have stated (and I concur) that the hydro pump on a C is modest at best. When used for articulating a 3pt they either lift well for short lift stroke, or only light loads with a stroke of 15-18 inches. Putting a cylinder on the hitch results in similar issues. If large enough to do the job, they are slow slow slow. If small enough to move swiftly, they are wimpy.
A solution may be to use a upper cross shaft with arms that have multiple holes at differing lengths from the anchor point. This would allow the hitch to be adjusted to be powerful and limited in lift height, or lon in lift and weak. (or inbetween if several holes were drilled. Tie rod ends from line haul trucks are great on the top of the lift links.
I hope this helps.
JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]