|
Farmall Tractors Discussion Board |
Re: Implements for a WD9
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Ron on January 03, 2000 at 06:50:13 from (155.226.255.194):
In Reply to: Implements for a WD9 posted by Robert on January 02, 2000 at 20:23:32:
I have a lot of experience with a WD-9 and WDR-9. They would pull a 4-16 bottom moldboard plow, 14 ft tandem disk, 5 blade disk plow, 16 ft Graham Hoeme chisel plow, 14 ft field cultivator with harrow behind. (These loads weren't exactly equal, the Graham Hoeme was the biggest load that I saw them pull; that really worked it hard) If I remember correctly they were about 45 drawbar HP. In the area where I grew up in North Dakota every farm had either a WD-9 or a John Deere R as their main tractor in that era. (I hope I don't get smacked for mentioning the green!)
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
