Re: super a engine bearings

Posted by werwowance on December 29, 2005 at 07:50:08 from (216.145.90.20):

In Reply to: Re: super a engine bearings posted by El Toro on December 29, 2005 at 06:45:47:

so, it is possible to change without pulling crank. can the crank be measured with it in, just caps off? im wondering if there is enough room to get a mike measurement without dropping it. i just hate realigning the clutch pilot, dropping my belly mower pulling front seals and every thing off.

also what is spec size for mains and rods on that crank, and if it hasnt been truned down but is worn enough should i use a over size bearing?

thanks

Replies:

• Re: super a engine bearings El Toro 09:58:47 12/30/05 (0)
• Re: super a engine bearings El Toro 08:17:33 12/29/05 (2)
  • Re: super a engine bearings werowance 08:27:56 12/29/05 (1)
    • Re: super a engine bearings El Toro 09:49:33 12/29/05 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]