Farmall & IHC Tractors Discussion Board |
Re: Farmall H wiring
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BillyinStoughton on December 29, 2005 at 14:38:18 from (208.50.85.56):
In Reply to: Farmall H wiring posted by Don Keller on December 29, 2005 at 13:47:38:
To get through the distributor versus magneto problem, lets get back to the basics. Is there an EXTERNAL coil mounted along side your ignition distribution source? It will be a cylinder about four inches long and a couple of inches inches wide with two lighter gauge wire connections with one "plug" type wire coming out the top. If you have this particular piece, it is a distributor type ignition, if you don't...it's a magneto. If we can establish this, we will have the basis to begin to help you out. The boys on here are pretty knowledgable and always willing to help. Good luck!
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|