|
Farmall & IHC Tractors Discussion Board |
Re: Help me.. Clutch.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Steven@AZ on January 22, 2006 at 13:57:43 from (24.121.48.188):
In Reply to: Re: Help me.. Clutch. posted by Kelly C on January 22, 2006 at 13:27:44:
I would take the flywheel to a machine shop to be measured. There is a specific limit on wear. We figured out why the 544 was getting jumpier toward the end of the clutch life -- the flywheel was worn so badly that the bolts holding it on were catching on the inner part of the clutch disk! Sounds like for what you are going to use it for, put the full face fiber disk in it. I would rather pay for the replacement clutch disk than what that flywheel cost us on the 544!
Replies:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
