|
Farmall Tractors Discussion Board |
Re: Super A 3 pt / pto poser...
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Mike on January 07, 2000 at 04:58:25 from (198.133.22.66):
In Reply to: Super A 3 pt / pto poser... posted by Rob on January 07, 2000 at 02:16:42:
Rob, I was thinking about the same thing as what you
did for your Super A, I just haven't done it
yet. According to the folks at Woodhouse, the
PTO on the Super A will be offset at around 15
degrees. You could run certain types of implements. They did mention if I were to put
a rear mounted rotary mower, to make sure that
it could cause too much excessive weight on the
back, causing the front to come off the ground.
But go to this sight http://www.worksaver.com
Click on distributors and you will see J.S.
Woodhouse and give those guys a call. Or you
may want to give the folks that you purchased
the adapter kit from before first. Mike
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
