Farmall Tractors Discussion Board |
Gas caps on a Regular
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Ludwig on January 07, 2000 at 06:06:37 from (208.201.105.20):
Tomorrow I will, by hook or by crook, get the cap off of the starting tank for my Regular. First some background, the cap is not at all like the caps on the letter series tractors, its nearly flat, has no writing on it, and has slight milled edge for grip, like on a quarter. I haven't been able to get it off by hand, with large channel locks, or a large pipe wrench. I filled the tank with oil from the other end and sat it upside down for a few months, only to have the oil leak out through the air vent in the cap. Tommorow I will apply heat to the next of the tank and then try turning, if that doesn't work I will carefully make two bisecting cuts across the top of the cap, quartering it and then remove the pieces. I'd rather not cut, so if anyone has any ideas, now would be a good time. Also if anyone knows where I can get a new cap I'd really appreciate it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|