Farmall & IHC Tractors Discussion Board |
Re: H with a mag
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MagMan on February 03, 2006 at 16:00:35 from (205.188.116.133):
In Reply to: H with a mag posted by Sponz on February 03, 2006 at 15:09:01:
As the rest have said you never have voltage going into a mag. Every mag I rebuild has a paper in it that say I dont know what you know about mags but I have to asume you dont and never never hook up an external power source to a mag it will fry it internally the screw on the side is for a push pull type grounding switch only. . NOW you dont throw away a mag for a distributor either. Mags when rebuilt properly will give years of service without much matenence.and specially with a 6 volt starting system or crank start much better also. I can rebuild your mag for you for a bout the same price as a good distributor if you like just let me know. hope this helps JON
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|