|
Farmall & IHC Tractors Discussion Board |
Re: F12 Cam Bearings
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KevinH on February 10, 2006 at 16:05:22 from (69.59.112.142):
In Reply to: Re: F12 Cam Bearings posted by El Toro on February 10, 2006 at 14:53:54:
The F12 only used the Wauki(listed in the TC9-B parts book as the 'FL') for the first couple years, then went to the IH engine(serial#'s 600-608 and 3035 and up). I have the IH engine and I put 4 sleeve assemblies in it from NAPA that their book listed for the 113 and they matched the ones I took out exactly. I used my original rods and cam. It's been running since '97 so I feel confident the parts matched. And it had cam bearings(the parts book lists them for the IH engine as 31185D or 24515d(front) 31186D or 24420D(center) and 31187D or 24516D(rear).
Kevin
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
