Farmall & IHC Tractors Discussion Board |
Re: Farmall 400 Power Steering Installation Questi
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave Slater on February 12, 2006 at 05:50:15 from (64.12.116.65):
In Reply to: Farmall 400 Power Steering Installation Questions posted by Troy in MI on February 11, 2006 at 16:41:54:
Yes the lower hole between control valve and reservoir tower,not between priority valve and tower.When factory plug not available I tap and plug the tower with a recessed head plug .I guess would work on other side but make sure o ring can work back between housings or it will leak unless both sides are pluged.Make sure all metal cuttings are removed.You are using the control valve with one outlet hole in center toward front with short steel line to priority valve?
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|