|
Farmall & IHC Tractors Discussion Board |
Can you ID this IHC cast cover plate ???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Way Up Here on February 17, 2006 at 07:29:06 from (64.42.242.6):
I have a cast iron part here that is circular in shape, about 7 inches in diameter with a raised edge. It is about 1/4" thick. It has the IHC logo emblem in the center and part number 183N below the IHC logo. The upper part of the circular plate bulges out and there is a hole drilled in there which the plate would pivot on if bolted or attatched to something. At the bottom there is a raised part that is obviously used for your thumb and finger to grasp to swing the plate out of the way. It seems that it might be a dust cover or lid of some type, perhaps from an implement or maybe even a tractor? I wish I could post a photo but this description is the best I can do.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
