Farmall & IHC Tractors Discussion Board |
Re: Schaver post drive on H?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Robhkent on February 20, 2006 at 09:17:04 from (157.130.169.110):
In Reply to: Schaver post drive on H? posted by dph on February 20, 2006 at 08:56:22:
DPH: I am using a shaver # 8 driver on an 856. I have a lot more tractor than I need. I think the H will handle the weight. If memory serves the whole driver w mounts etc.. should weigh about 500#. I don"t know the GPM on an H pump. I fyou go online to Shaver mfg, the manual on the driver will give you the gpm required. I would want to exceed the required amount if I were you. I am moving my driver to my 560, and am anticipating no problems with it there. Rob
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|