Farmall & IHC Tractors Discussion Board |
Re: Farmall M Packing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Farmall Frank on February 23, 2006 at 16:29:44 from (69.76.145.131):
In Reply to: Farmall M Packing posted by LBH on February 23, 2006 at 14:05:02:
I rebuilt my 400D because it was leaking and tightening the gland didn't help. When I took it apart I discovered that the shaft was shot --- worn/rusted out, making the shaft out of round. Any tightening of the gland would only work for a short while. The shaft only cost $179 through IH!!!! Pump was no longer available, rebuilt or new, so it was either used or rebuild it myself. All of the parts were available from IH. It cost me about $300 to rebuild it, and it works great now. The packing is available through IH for about $8 a piece, and it took 5 pieces for a complete repacking. If you only need packing, it should only take 1 or 2 pieces.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|