|
Farmall & IHC Tractors Discussion Board |
400 Torque Amp.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by AdamD on February 25, 2006 at 13:58:49 from (64.184.6.242):
Decided to try and figure out why the torque in my Farmall 400 that I purchased last spring wasn"t worknig. Took the inspection plate off and did some adjusting and everything is working like it is supposed to. By what the service manual is showing and telling me, I fell the over running clutch has worn out and isn"t holding the planet carrier when it gets under a load. Since that could be the only problem, is it possible to just replace the over running clutch (have to find out what all that consist of) or would it be better to just get a rebuilt unit? If so, where is a good place to start looking? Is the T/A repair video on here worth purchasing or would someone be willing to sell a used video? Thanks.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
