Farmall & IHC Tractors Discussion Board |
Re: Super C oil check
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fluggie in IA on March 15, 2006 at 10:24:07 from (216.51.138.241):
In Reply to: Super C oil check posted by LiverNips on March 15, 2006 at 09:19:50:
There are two oval shaped wing bolts on the side of the oil pan. The higher one is for the "Full" level of oil and the lower one is the "Add" level which is one quart low. the "wings" turn counter clockwise and may be pretty tight as most folks tighten them with a pliers so a pliers is usually needed to loosen them. Back off the lower one about 1/2 to 1 turn and, if the oil drips, it's ok. When filling it up afte a change or if it's low, open the upper one and when the oil drips then you are full. Retighten and you are good to go.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|