Farmall & IHC Tractors Discussion Board |
Re: ih 340 question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K.B.-826 on March 23, 2006 at 19:17:42 from (24.180.143.103):
In Reply to: ih 340 question posted by jim gordon on March 23, 2006 at 18:31:44:
They were built from '58-'63, Check your serial number, it's on the tag riveted to the left side of the clutch housing. Compare your serial number to the list found under "Research & Info" on the left side of this page. No, a 340 U really isn't a collector tractor, unless it's been perfectly restored. There's a ton of them out there. As for history, this site is the best place for info, all you gotta do is ask. A 340 U is basically an updated version of the 330 U built from about '56-'58. The 330 U was pretty much a totally new size of tractor for IH when it was introduced. It used a C-135 engine, which was based on the design of engine used in the small tractors, while using the big tractor transmission/rear end. A Row-Crop (Farmall) version of the 330 was never built, while the 340 was offered in both Row-Crop and Utility versions. The 340 continued to use the C-135 gas engine, and was also avalible with a D-166 diesel engine, unlike the 330. The model 504 replaced the 340, and was built until '67. Once again, the 504 was avalible as a row-crop or a utility. The engines were of the same design as the 340's, the gas engine was now the C-153, and the diesel was a D-188. The 544 Row-Crop and Utility followed, and they had quite a few improvements. their C-200 gas and D-239 diesel engines were of totally different designs. The 544 continued to use the 5-speed gear drive transmission with optional TA, and the new Hydrostatic transmission was optional. the last U.S.-built IH utility tractor was the 664, which replaced the 544. 664's were only offered as a utility, and are very rare. The 574 British-built utility replaced the 664, and the 574-style design continued to be used by IH and Case-IH right up into the 1990's.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|